App Features - Wilfa Innobot Anleitung

• Manual recharge: In standby mode, press the recharge button to send the
robot back to the dustbin station.
• Automatic recharge: The robot will automatically return to the dustbin station
when it finishes cleaning or if the battery is low.
• Dust collection: When the robot is charging, the dustbin station will
automatically collect dust. If it is in Do-not-Disturb-mode, the robot will return
to the dustbin station to charge, but it will not collect dust.
• Add water or clean the mop during cleaning: If you need to add water or
clean the mop while cleaning, press the power button to pause the device.
Then, remove the water tank and mop, add water or clean the mop, and put it
back. Press the power button again to resume cleaning.
• Sleep mode: When the robot has been 5 minutes without any activity, it will
automatically enter sleep mode. If it stays in sleep mode for more than 6
hours, it will automatically turn off. To wake up the robot, press any button or
use the app.

APP FEATURES

Download the app to customize these features and maximize the performance of
your robot vacuum cleaner.
• Quick map: Place the robot on the dustbin station and select this mode in the
app to build a map without cleaning. After the robot automatically return to
the dustbin station, the map will be completed and saved automatically.
• Memory map: After the robot successfully completes a quick map or cleaning
and returns to the dustbin station to recharge, the map is automatically
updated and saved. After the map is successfully built, you can divide, merge
areas or customise room names in the app.
• Full house cleaning: Start full house cleaning through the app or by pressing
the power button. The robot will first carry out full house cleaning along a set
path, then carry out edge cleaning.
• Edge cleaning: Select this mode in the app for the robot to clean along the
edges of rooms.
• Area cleaning: Define a specific area in the app, and the robot will clean only
that area.
• Fixed-point cleaning: In the app; choose a target point on the map for the
robot to clean a 2x2 meter area around it.
• Scheduled cleaning: Use the app to set a cleaning schedule. The robot will
start and return to the station automatically.
• Do-not-Disturb mode: During this period (default 22:00 to 08:00), the robot
won't perform scheduled or resume cleaning and will minimize voice prompts.
You can enable/disable or set the time period of the mode in the app.
• Virtual wall/No-go area: Set up virtual walls or no-go areas to prevent the
robot from entering areas. Before using the virtual wall/no-go area function,
you need to save the map in the app. Moving the robot or major changes in
15
EN