Cleaning & Maintenance; Main Brush - Wilfa Innobot Anleitung

the environment can cause the original map to become invalid and result in
the loss of virtual walls/no-go areas.
EN
• Reset Wi-Fi: When the mobile phone cannot connect to the robot, reset the
Wi-Fi by long pressing the power and recharge buttons.
• Factory reset: Press and hold the recharge button for 5 seconds until you hear
a prompt, then press and hold for another 5 seconds for a factory reset. The
robot needs to reconnect to the app, and all related settings in the app will
be cleared.
• Firmware upgrade: The robot's firmware can be upgraded through the app.
During the upgrade process, the robot must be connected to the dustbin
station or have a battery power more than 30%. Do not start a cleaning
process during the upgrade.
CLEANING & MAINTENANCE
Note: Turn off the device before performing any of the following steps!

MAIN BRUSH

The provided cleaning brush has sharp blades, keep it out of reach of children.
1. Disassemble the main brush by turning the robot over, lift the buckle and take
out the main brush.
2. Clean it by using the provided cleaning brush. Use the side with the hook to
pick up and cut hair and fibre and separate it from the main brush. Use the
cleaning brush to clean surface dirt. We recommend replacing the main brush
every 6-12 months.
Buckle
16