Installation; Use - Wilfa Innobot Anleitung

INSTALLATION

EN
INSTALLING THE DUSTBIN STATION
1. Choose a suitable location against a wall with enough space around it.
2. Mount the floor protection pad if the floor material needs moisture protection
from the wet mop.
3. Plug the station into the power supply.
4. When using the robot for the first time, press and hold the on/off button to
power it on, then place it on the dustbin station for charging.
> 0,5 m
> 1,5 m
INSTALLING THE MOPPING MODULE
1. Attach the damp mop to the Velcro on the mop holder.
2. Open the rubber cap on the water tank, fill it with clean water, and securely
fasten the cap.
3. Attach the mop to the bottom of the water tank as shown in the illustration.
4. Push the water tank into the robot until you hear a "click", indicating it's
properly installed.

USE

• Power on/off: Press and hold the power button for 3 seconds. The indicator
will light up when the robot is in standby mode.
• Press and hold the power button to turn it off, and the indicator light will turn
off.
• Start/Pause: In standby mode press the power button. The robot will begin
cleaning, and you can pause it by pressing any button.
> 0,5 m
14