Nice E MAT ST 1011 Kurzanleitung Seite 12

sec.
04
...
move the awning in the "S" position
Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
5.16 - Total or partial deletion of memory
This procedure allows you to choose under point 05 the data that you want to delete.
5.16.1 - Procedure performed with a transmitter memorised in "Mode I"
Before starting the procedure, bring the awning to the midpoint of its stroke.
01. Keep the n key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the s key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
03. Keep the n key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
04. Keep the t key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
05. • To cancel the entire memory: Keep the s and t keys pressed and wait for the motor to perform five movements. Upon completion, release the keys.
• To delete all memorised transmitters: do not press any key and wait until the motor performs 5 movements.
• To delete a single memorised transmitter: hold down the s key and wait for the motor to perform 3 movements. Now release the key. Lastly, press the but-
ton of the transmitter you wish to delete: the motor performs 5 movements.
• To cancel just the parameters: keep the n key pressed and wait for the motor to perform 5 movements. Upon completion, release the key.
01
5
sec.
04
3
5
sec.
05
all
...
05
(*)
"0"
"1"
5
"H"
sec.
Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
5.16.2 - Procedure performed with an unmemorised transmitter
Before starting the procedure, bring the awning to the midpoint of its stroke.
01. Disconnect power supply from motor.
02. Connect the White and White-black wires to each other.
03. Disconnect power supply from motor.
04. Lastly, perform the procedure indicated in paragraph 5.16.1.
11 – English
( )
"1"
"1"
"S"
02
2
choose an
option
single
5
5
sec.
05
"S"
fine adjustment
3
5
sec.
05
all
data
5
sec.
05
3
5
sec.
sec.
3
5
sec.
03
3
5
sec.
5
any button
(transmitter
to be
deleted)
5