Tecfrigo PARTY vc Bedienung Und Instandhaltung Seite 18

The instructions drawn up by Tecfrigo include the manual and the signs on the machine and
control parts. The laws and regulations in force in the country where the machine is being used
may entail greater safety provisions or identify further risks with respect to the ones listed in the
manual.
• They must have had actual training on the operations to be performed. Maintenance workers
must have read the instructions in this manual and be familiar with all the commands so that
they can work in full compliance of the safety regulations currently in force.
• They must not be drug or alcohol abusers. The use of these substances impairs ready
reflexes and coordination. A technician who uses prescription drugs must obtain medical advice
on his ability to conduct certain types of activities.
CLOTHING
Before starting any work operation, maintenance workers must wear suitable clothing that
respects the indications envisioned by current regulations. All the instruments that are used
must be in perfect condition and be typetested. The maintenance worker must ALWAYS check
the supplied devices and replace them if they are damaged or are not compliant. Listed below
is a table with the devices the Tecfrigo recommends.
IMPORTANT TOOLS FOR MAINTENANCE PERSONNEL
WEAR PROTECTIVE GLOVES
WEAR GOGGLES (DURING WELDING WORK)
WEAR SAFETY SHOES
WEAR WORK OVERALLS WITHOUT ANY LOOSE ENDS
CLEANING THE GLASS STRUCTURE
Maintenance of the glass structure is very simple but it must also be done carefully due to the
type of elements it comprises. It must be cleaned weekly using warm water and Marseilles
soap.
NEVER use inflammable or abrasive products. NEVER spray water to clean the display case.
To clean the display section, you need to remove all the products. Then you need to open the
front glass. At this point, you can clean this section.
FRONT GLASS
CLEANING THE PLASTIC AND PAINTED PARTS
FIG.17
lean these parts with warm water and neutral
Marseilles soap. Dry well with a soft cloth (the
display case must be turned off and disconnected
from the power mains).
ATTENTION
NEVER use inflammable or abrasive products.
NEVER spray water to clean the display case.
CLEANING THE DISPLAY SECTION
To clean the display section, you need to remove all the products. At this point, you can clean
this section. Use only warm water and neutral Marseilles soap. Dry well with a soft cloth (the
display case must be turned off and disconnected from the power mains). Verify that the
display case is turned off and that it is disconnected from the power mains.
ATTENTION
NEVER use inflammable or abrasive products.
NEVER spray water to clean the display case.
Tecf
18