Connectors - Seh Inu-100 Hardware-Installation

Connectors

power supply 1
(You can find this circuit diagram on the INU server's side.)
Power supply
The INU server can be supplied via 2 power sources. One
power source takes over the supply. A second power source
can be connected as an additional redundant power supply if
required.
WARNING
The INU server and the power supply or power
supplies must be installed in the same control
cabinet. And the low-voltage cable between the
power supply or power supplies and the INU
server must not be longer than 3 m.
Power supply
connection:
5
normally
closed
power supply 2
1: Connectors 1 + 2
2: Connectors 3 + 4
via screw terminals
[en]
normally
open
Hardware Installation Guide