Busch+Müller TURNTEC Montage- Und Bedienungsanleitung Seite 14

The rear indicators of the set C are spring-mounted and therefore protected against knocks and / or
unintentional breakage.
Using the adapter plate for rear light assembly, a rear light with 50 mm or 80 mm bolt spacing can
D
be firmly mounted on the rear indicator set
onto the rear indicator set C and mount it using the enclosed screws
the position of the indicator and the rear light are vertically offset to ensure that the side light emission
of the rear light is not covered by the indicator.
WARNING To avoid falls, accidents and serious injuries, only use the pre-mounted components
from Busch+Müller. If unsuitable or improperly positioned brackets are used for assembly, a component
may come loose, slip off and get caught in the wheel spokes.
Please check that all components are securely in place before using the bike.
7. Electrical connection
7.1. Cabling
NOTICE
To prevent short circuits and possible damage, the system must be fully assembled and all
connections linked before the system is connected to the bike's power supply. Therefore, make sure
that the bike is disconnected from the power source (e.g. battery) during assembly!
The cable harness E + F is divided into two parts (see Image 2).
The front and rear part are connected by connectors and can be separated for ease of assembly.
The front cable harness includes the connectors for the control unit
E
26
C . For this purpose, place the adapter plate
!
With the adapter plate in place,
and the front indicators
A
as well the cable to the DC power supply
for the rear indicator set
Due to their size, the distribution points of the wiring harness must be mounted externally on
D centrally most E-bikes.
Install the front cable harness
and connect the control unit
!
Observe the cable designation on the cable harness and on the control unit connector. The
arrows must point towards each other!
The connection for the rear cable harness
motor or DC supply source
!
Observe the cable designation on the cable harness for the left and/or right indicators!
!
For frame internal assembly, ensure that sufficient space is available for the battery to allow
for frictionless installation and removal.
Install the rear cable harness
the motor and connect the rear indicator set
! Observe the cable designation on the cable harness for right and left, respectively!
B
G . The rear cable harness F
.
C
E from the position of the front indicators
A and the front indicators B to the cable harness.
F and the power supply cable should be close to the
and easily accessible for the following assembly steps:
G
F working from the position of the rear indicator set
C to the rear cable harness
includes the connectors
B towards the motor
C towards
F .
27