Busch+Müller TURNTEC Montage- Und Bedienungsanleitung Seite 13

Both front indicators [B] must be mounted with 7.5 cm minimum distance to the headlight and at least
24 cm apart from each other.
For more information, check the Road Traffic Regulations or, alternatively, contact a local specialist
bicycle retailer.
5. Packaging content
Two front indicators on support bracket arms with fastening clamps and screws| Rear indicator set and
screws| Control unit | Adapter plates incl. screws and nuts | Two-piece cabling harness | 2 Textile cable
ties |Assembly and Instruction Manual
24
6. Assembly
Left front indicator support bracket
B
arm with fastening clamp
Control unit A
Attach the control unit A to the left front indicator on support bracket arm bars using the
fastening clamp B .
For this purpose, screw the parts together as shown in sketch no. 3.
The two front indicators on support bracket arms are each attached to the handlebars using a
B
handlebar fastening clamp and the enclosed screws (tightening torque 4 Nm max.). Also, attach
the control unit A for the indicator to the left holding bar so that it can be operated whenever
you want without having to take your hand off the handlebars.
Please ensure that the front indicators B are mounted with the light surface facing forwards and
on the correct side (left or right, respectively - see Image 1). Other attachment components on
the handlebars may have to be temporarily removed or displaced for the assembly.
25