Start-Up; Resetting To Factory Settings - Bosch Bth-Rm230Z Bedienungsanleitung

Room thermostat II 230 V
Display
Level
1 2
UFH
NC
HT
CL
NO
HT
CL
VFH – –
RAD – –
݅ After connecting the room thermostat to the Bosch Smart Home system,
you can also adjust all device settings in the Smart Home app.
‫ ܬ‬You can also use the explanatory videos and additional information on
our website as an additional aid for mounting, installing, starting up
and restoring the factory settings on your Bosch Smart Home room
thermostat II 230 V:
→ https://www.bosch-smarthome.com/rom/room-thermostat-2-230V

Start-up

Ensure that you have a Bosch Smart Home controller and the Bosch Smart
Home app and have successfully configured both. Now start the Bosch
Smart Home app and select "Add new device". Follow the instructions in
the app.

Resetting to factory settings

You can reset the device to its factory settings as follows:
Remove the control unit from the in-wall housing. When reinserting it, hold
the rotary knob (4) until "RES" appears on the display. Release the rotary
knob and press it again. The device then restarts. Please note that it can
take a few seconds until the room thermostat is ready for operation again.
݅ When resetting to factory settings, the settings and information are only
lost from the device and not from the Bosch Smart Home controller.
݅ To re-configure the device, first delete it in the device management
section of the Bosch Smart Home app and then add it again in the usual
pairing process.
↑Contents
8-750-002-893 | V001 | 01/2024
Description
3
Potential application, e.g. 230 V/24 V actuators
Normally closed actuator
Heating mode
Cooling mode
Normally open actuator
Heating mode
Cooling mode
Potential-free application, e.g. boiler
Radiator, operation with 2nd generation Bosch Smart Home radiator
thermostats
English | 14
Bosch Smart Home