Operation With Boiler - Bosch Bth-Rm230Z Bedienungsanleitung

Room thermostat II 230 V

Operation with boiler

230V
AC
L
N
Connection Description
L External conductor (230 V
N Neutral conductor
COM Voltage-free input.
NO Voltage-free input.
S1/S2 –
Attach the in-wall housing to the wall box using suitable screws. Pay
attention to correct orientation (Bosch writing at the top and readable).
Place the control unit on the in-wall unit and press it in until it clicks into
place.
Now switch the power back on.
As soon as the room thermostat is connected to the power supply, pairing
mode starts and is active for 3 minutes. Pairing mode can be restarted at
any time by pressing the system button (4).
݅ The room thermostat can also be operated independently, with no
connection to the Smart Home system. The range of functions is then
essentially limited to displaying and controlling the room temperature
in conjunction with the connected heat generator according to the
preset target temperature in the manual operating mode (without a time
program).
In the event that an initial start-up is required without a Smart Home
system (e.g. new build), basic settings can be made on the device via an
installer mode. To this end, press and hold the rotary knob (4) for at least
3 seconds until the display shows "INS". By turning the knob (4) you can
make a selection and confirm the selection by pressing it.
↑Contents
8-750-002-893 | V001 | 01/2024
)
AC
English | 13
Bosch Smart Home