Parkside PSSFS 3 A2 Bedienungs- Und Sicherheitshinweise Seite 13

Move the tip
When the product detects AC voltage, the red LED
flashes and the buzzer beeps once . The closer you move
the product to the wire or socket, the higher the flashing
frequency of the red LED and the beeping frequency of the
buzzer .
Switching off: Press the
LED goes off . The buzzer beeps twice .
NOTES:
The tip
[ 6 ]
For different wires or sockets to be tested, the product's
detection sensitivity may be different . This is normal .
If the buzzer has been disabled, the product will not beep
during detection (see "Disabling the buzzer's beep sounds
during operation") .
˜ Flashlight
Turning the flashlight on: Press and hold the button
Turning the flashlight off: Release the button
˜ Cleaning and care
Do not allow liquids to enter the product . Otherwise the
product may be damaged .
Do not use abrasive cleaning agents, cleaning alcohol or
other chemical solutions since these could damage the
housing or even impair operation .
Use a dry, lint-free cloth for cleaning .
The product is maintenance-free . No components need to
be maintained by you inside the product .
Keep the product clean to ensure fault-free operation .
14 GB
close to the wire or socket to be tested .
[ 6 ]
must be close enough to the object to be tested .
button again . The green
1 ] [
.
2 ] [
.
2 ] [