Connecting The Transmitter To A Existing Bell System; Connecting A Existing Doorbell Button - Silvercrest Z32139 Montagehinweise Und Bedienungshinweise Und Sicherheitshinweise

Extension of an already existing doorbell system:
An already existing doorbell system can be extended with this wire-
less doorbell.
The connection clamps A and C on the backside of the transmitter
must be directly connected with an approx. 50 cm long, 2-wired cord
(bell cord) to the connections of the already existing doorbell system.
The distance between bell and transmitter should be at least 30 to
40 cm.
Note: Contact a qualified electrician in case of problems during
installation.
The separate bell button must not be connected to the existing door-
bell system. The battery must remain in the transmitter. The B and C
terminals are to this purpose with a two-core cable connected to the
bell push.
Possibly existing glow / light bulbs must be removed. The doorbell
button is used must be non-illuminated.
43150_Funktürklingel_content_GB_IE_SE_DK.indd 19
Connecting the transmitter
to a existing bell system (see Fig. I)
Connecting a existing
doorbell button (see Fig. J)
GB/IE 19
26.03.14 15:57