Selecting The Chime; The Procedure For Connecting The Transmitter To Existing Bell System Or Existing Doorbell Button - Silvercrest Z32139 Montagehinweise Und Bedienungshinweise Und Sicherheitshinweise

Note: The doorbell has 16 different chimes.
18 GB/IE
43150_Funktürklingel_content_GB_IE_SE_DK.indd 18

Selecting the chime

Press the melody selection button
sounds.
Press the melody selection button
next audible signal.
Repeat this process until you have selected your desired audible
signal. The last-selected audible signal is automatically stored.
The procedure for connecting the
transmitter to existing bell system or
existing doorbell button
Remove the holder
from the back of the transmitter and remove the rubber cover
(see fig. C1).
Open the inner cover
Remove the plastic clip of cable exit hole
screw driver (see fig. G).
Insert the cable through cable holder
(see fig. H).
Connect cable to A/C terminal (for connecting to existing door-
bell) or B/C terminal (for connecting to existing door bell button)
by using screw driver (see fig. H).
Note: there is no polarity different for A or B terminal connect
to C terminal.
. The first audible signal
4
again to move on to the
4
with the help of flat head screw driver
12
by cross head screw driver (see fig. F).
14
19
with a flat head
18
and cable exit hole
15
18
26.03.14 15:57