Technical Specifications; Recycling; Delivery Set - Rondell Rde-1114 Betriebsanweisung

Problem
Milk is not flowing into the froth-
ing and dispensing system
The coffee maker display shows
the message that the used
coffee grounds container is not
installed, though it is installed
to its place
The display shows the «Water
tank» icon
The brew is too weak
Coffee is not poured into the cup The water tank is installed improperly
STORAGE
– Before taking the unit away for storage, unplug it and let the
unit cool down completely.
– Clean the unit.
– Do not leave, use and keep the unit in places with the tem-
perature below 0°C.
– Keep the unit in a dry cool place out of reach of children and
disabled persons.
TRANSPORTATION
– Keep the original packaging of the coffee machine for safe
transportation.
– Drain all water from the coffee machine tank and its internal
parts, wipe it dry with a soft cloth.

DELIVERY SET

Coffee Machine – 1 pc.
Milk tube with a tip – 2 pc.
Stainless steel platform for heating cups – 1 pc.
Possible reason
The frothing and dispensing system is
clogged
The milk tube is installed incorrectly
The used coffee grounds container
sensor is blocked
The water tank is empty
The grinding is too fine
To make drinks, dark roasted coffee is
used, which emits a larger amount of cof-
fee oil, the coffee grinder knives get dirty
The coffee dispensing nozzles are
clogged up
Water dispensing tubes for brewing coffee
are blocked
Measuring spoon for coffee (for 5 g) – 1 pc.
Soft brush for cleaning the brewing unit – 1 pc.
A set of spare silicone rings for the brewing unit – 1 pc.
Plug for milk system inlet – 2 pc.
Instructions with warranty card – 1 pc.

TECHNICAL SPECIFICATIONS

Power supply: 220-240 V ~ 50-60 Hz
Rated input power: 1300-1500 W
Water tank capacity: 1,6 L

RECYCLING

For environment protection do not throw out the unit and the bat-
teries (if included), do not discard the unit and the batteries with
31
Solution
Fully clean the frothing and dispensing system
in accordance with this manual
Recheck the milk tube, it should be firmly
seated on the frother
Remove the used coffee grounds container
and thoroughly clean all corners of the
container area with the soft brush supplied
with the unit, and clean all outer corners of the
container with a dry cloth
Fill the container with clean water and install
it in the slot behind the left door of the coffee
machine
Adjust the grinding by setting it to less fine
grind
While the coffee grinder is in operation,
change the position of the control knob. If the
problem remains, contact the service center
Fill the water tank and place it in the slot
behind the coffee machine's left door, press
on it until bumping
Clean the nozzles thoroughly with the supplied
brush
Carry out decalcination in accordance with
this manual. If the problem remains, contact
the service center