RONDELL RDE-1114 Betriebsanweisung Seite 30

When the cleaning cycle is completed, the following icon will ap-
pear on the display with further instructions (fig. 43).
– Drain the remaining cleaning solution from the tank (4) and
rinse it with clean water.
– Fill the tank (4) with clean water, without exceeding the «MAX»
mark, and put it back into the coffee machine.
– Press the « » icon to start the rinsing process.
As soon as the machine finishes the rinsing cycle, it will return to
standby mode.
Replacing sealing rings
The unit is supplied with sealing rings for the brewing unit.
Rings must be replaced if they are worn or damaged.
Troubleshooting
Problem
The coffee machine does not
switch on
The coffee grinder is making
odd noises
The coffee grinder doesn't work The coffee grinder motor has broken
Drinks pour slowly from the
coffee dispensing unit
The coffee machine displays a
notification that the brewing unit
is not installed even though it is
installed in the coffee machine
body
A small amount of coffee pours
into the cup from the coffee
dispensing unit
The milk is not frothing
ATTENTION! Replacement should be carried out when the unit
is unplugged.
– Open the brewing unit compartment door (11) of the coffee
– Remove the used coffee grounds container (13) (fig. 31).
– Remove the brewing unit (12) (fig. 32).
– Clean the brewing unit by immersing it in a container with clean
– Replace the sealing rings on the brewing unit according to the
WARNING SIGNALS AND ICONS
When warning symbols/icons (fig. 47-56) appear on the display,
follow the appropriate instructions.
Possible reason
The unit is unplugged from the mains
The coffee grinder is clogged
There are foreign objects caught up in the
coffee grinder
There are foreign objects caught up
in the coffee grinder
The grinding is too fine
The brewing unit is clogged up
The brewing unit has been installed
incorrectly
The water dispensing system is clogged
with the residual scales
The milk frother is clogged up
The milk frother is installed incorrectly
The control knob is set incorrectly
This type of milk is not suitable for frothing For best results, use whole milk
30
machine (fig. 30).
water for 30-40 minutes.
drawings (fig. 44-46)
Solution
Plug the coffee machine into the mains
Clean the coffee grinder according to this
manual
Unplug the coffee machine from the mains,
remove foreign objects from the coffee grind-
er and wipe it with a dry cloth
Contact the service center
Unplug the coffee machine from the mains,
remove foreign objects from the coffee grind-
er and wipe it with a dry cloth
Adjust the grinding by setting it to less fine
grind
Clean the brewing unit
Check the brewing unit and reinstall it
in accordance with this manual
Descale the coffee machine in accordance
with this manual
Fully clean the milk system and milk tubes
Check the milk frother and reinstall it in accor-
dance with this manual
Adjust the intensity of the frothed milk dis-
pensing the knob (15)