Moving The Machine; Adjusting The Resistance; Replacing The Batteries - Jll R200 Benutzerhandbuch

MOVING THE MACHINE

To move the machine, lift the end of the
slideway until the transport wheels touch
the floor. Then move the rower to wherever
you would like.

ADJUSTING THE RESISTANCE

Rotate the tension control knob clockwise
to increase the level of resistance. Rotate
the tension control knob counter-clockwise
to decrease the level of resistance.
Level 1 is the lowest and level 10 is the
highest.

REPLACING THE BATTERIES

Two "AA" batteries are included in the
monitor. To replace the battery, remove the
monitor from the main base by lifting the
clip underneath. This will pop out the
monitor and allow you to change the
battery.
NOTE: The sensor wire can be
disconnected to give you better access to
the monitor. Remember to reconnect after
replacing the battery.
16