R200 Assembly - Jll R200 Benutzerhandbuch

R200 ASSEMBLY

The rower has been assembled and tested at the factory, so you shouldn't have any
problems putting all the parts together. Components are designed to fit together, and
only basic tools are required for the assembly process. Inside the box you will find a Tools
Pack (Hex Allen Key, Spanner, Washers and Bolts). See previous page.
To assemble your JLL R200 please follow these easy steps:
STEP 1
Remove the cardboard tube from
the rear of the base and reattach the
stabilizer using the two M8
carriage bolts, D8 arc washers and
M8 cap nuts.
STEP 3
Attach the stand rail to the front of
the slideway using an M10 hexagon
bolt, two D10 flat washers and M10
nylon nut.
STEP 2
Remove the two cushions and two
M6 screws from the slideway.
Slide the saddle onto the slideway
and reattach the cushions and plate
from your tools pack using the two
screws.
STEP 4
Place the protective guard over the
stand rail and secure it in place using
the four screws.
The screws will come attached in the
back of the protective guard.
13