Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If the engine has not started after
two attempts, try a warm start wi-
thout the choke in the warm start position.
If this is not successful, follow the instruc-
tions in the "Troubleshooting" section.
Cold start, Fig.
• Starting with the electric start:
1. Place the device on a firm level sur-
face. Make sure that the cutting tool
does not touch either other objects or
the ground.
2. Set the choke lever (7) to position
3. Press the fuel pump (primer) (6) six
times.
4. Insert the Parkside X 20 V Team battery
(34).
5. Fold up the cover and press the electric
starter (3).
If the device does not start after
pressing the electric starter (3) 3-4
times, then set the choke manually
to position
6. Press the throttle lock (22) and then the
throttle lever (23) briefly to enable the
choke lever to move to position
The device begins to idle.
Allow the tool to warm up at
idle for between 45 seconds
and 1:30 minutes.
7. To mow, keep the throttle lock (22)
pressed down and operate the throttle
lever (23).
8. To switch off the engine, briefly press
the on/off switch (21) to
If the engine has not started after
two attempts, try a warm start wi-
thout the choke in the warm start position.
If this is not successful, follow the instruc-
tions in the "Troubleshooting" section.
:
.
.
.
Warm start, Fig.
• Starting with the starter rope:
1. Leave the choke lever (7) in its present
position
2. Hold the device firmly with one hand
by the upper shaft tube (19). With the
other hand, pull the starter rope on the
starter handle (2) quickly several times
in succession until the engine starts.
Attention! Do not pull the starter rope
out too far - Danger of breakage!
The device is now idle.
.
3. To mow, keep the throttle lock (22)
pressed down and operate the throttle
lever (23).
4. To switch off the engine, briefly press
the on/off switch (21) to
Warm start, Fig.
• Starting with electric start:
1. Leave the choke lever (7) in its present
position
2. Slide the battery (34) onto the guide
rail on the device head.
3. Fold up the cover and press the electric
starter (3).
The device is now idle.
4. To mow, keep the throttle lock (22)
pressed down and operate the throttle
lever (23).
5. To switch off the engine, briefly press
the on/off switch (21) to
Care and Maintenance
The maintenance and clean-
ing work must always be
carried out with the engine
switched off and the spark plug
connector removed (
Have any work not described in
these instructions carried out by
our service centre.
Never use metallic threads or saw
GB
:
.
.
:
.
.
1).
A
MT
51
Werbung
