Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. Then trap the end of each thread in one
of the grooves (61) on the spool (53).
Pull the threads tight and ensure that
they are parallel in the two thread
channels. In addition, the thread spool must
not be filled with more than 3 m of thread
in each channel, as otherwise the automatic
thread mechanism will not function correctly.
Lubricating the gears
The gears require lubrication after around
10 hours of operation.
:
Fig.
1. Loosen the screw (62) on the gears us-
ing the large 5 mm Allen key (32).
2. Insert around 5 g of commercially-avail-
able lubricating grease into the lubrica-
tion opening on the gearbox housing.
3. Close the gears again using the screw
(62).
Table "Maintenance Intervals"
Machine Part
Screws, nuts, bolts
Air filter
Fuel filter
Spark plug
Fuel hoses
Complete machine
Operating handle
Cutting head
Coupling
Lubricating the
Action
Check, tighten
Clean or replace
Replace
Clean/adjust/replace
Check, replace if necessary
Check, clean if necessary
Check for function
Check correct installation
Check that the device is sta-
tionary when idling
gears
Adjusting the Carburettor
The carburettor is preset in the factory for
optimal performance. If subsequent adjust-
ments are required, have them carried out
by a specialist workshop.
Removing blockages
Switch the device off and
remove the spark plug
connector (
1) before you work
A
on the cutting unit.
Wear protective gloves in order to
avoid cutting yourself.
Maintenance Intervals
Regularly carry out the maintenance work
listed in the "maintenance intervals" table.
Regular maintenance prolongs the life
of the equipment. It also gives optimum
cutting performance and avoids accidents.
Before
Each Use
GB
MT
Operating Hours
10
20
55
Werbung
