Parkside Performance PPBS 3 A1 Originalbetriebsanleitung Seite 46

GB MT
safe for operation. If there is any
doubt, do not start the equipment.
Remove the protective film from the
line cutter (
device for the first time.
Observe the following points in
particular:
• Check the cutting tools for damage and
wear.
• Correct installation of the cutting head
• Easy movement of all switches
• Secure sit of the spark plug connector.
If the connector is loose, sparks can be
formed and thus ignite any leaking fuel-
air mix.
• Check the correct function of the
coupling
• Ensure the handles are clean in order to
be able to guide the equipment safely.
• All safety and protective devices must be
properly installed and in place before
the equipment can be started.
The cutting head must be able to
run freely. Before starting the equipment,
ensure that the cutting head is sitting cor-
rectly and that the moving parts are free.
Warning! If there is any doubt,
seek help with the operation
of this equipment from a specialist
in an authorised service centre.
Filling with Fuel
Always ensure good ventila-
tion when handling fuel.
Do not smoke when filling with
fuel and keep away from any heat
sources. Never fill with fuel when the
46
49) before using the
engine is running.
Open the tank cap carefully,
so any excess pressure present can
be relieved slowly.
Start the equipment min.
3 m away from the fuel filling
location. Risk of fire or explosion in
case of non-observance
The filling volume
of the tank is 1200 ml.
Use only the fuel mix recommended
in the instructions. The fuel mix ages.
Therefore, do not use fuel mix that is older
than 3 months. In case of non-observance,
the engine can be damaged and the guar-
antee will be invalidated.
Avoid direct skin contact with
petrol and the inhalation of
petrol fumes. Health hazard!
operated exclusively with a mix of petrol
and two-stroke engine oil in the ratio 40:1.
Table of fuel mixtures:
Petrol
1,00 litres
3,00 litres
5,00 litres
Mixing
• Use quality unleaded petrol with an
octane rating of at least 90.
• For optimal performance, use oil for
air-cooled two-stroke engines.
The equipment is fit-
ted with a two-stroke
engine and therefore
Two-stroke oil
25 ml
75 ml
125 ml
40 parts of petrol
+ 1 part of oil