Siko MA501 Zusatz Zur Originalmontageanleitung Seite 17

MA501-SW02
Programming mode
5 Programming mode
Ex works, the display is delivered with standard settings or customized.
Switch over to the programming mode if you want to change the settings
and reprogram the device. Normally, programming is only necessary at
initial commissioning and set-up of the display or application, respec-
tively. You can change or check the parameters at any time. The values you
selected are stored non-volatilely. For designation, function and select-
able values refer to the table in chapter 6.
To enter into programming mode
Press key
To leave programming mode
No key actuation for at least 30 s, or press key
parameter list is reached.
To scroll parameter information
Press key
Input of numerical values
With the input of numerical values the smallest decade is the first to blink.
By actuating the
changed. The
To change parameters
Press keys
To store modified parameters
Press key
MA501-SW02 · Date 31.03.2017 · Art. No. 84935 · Mod. status 263/16
for at least 4 s.
.
key, the numerical value of the blinking digit can be
key serves for advancing to the next digit.
.
, then message "-STO-" will be briefly displayed.
English
until the end of the
17