Failures - Tunze 6060 Gebrauchsanleitung

Failure
(1) The pump does not operate.
(2) Turbelle ® stream 6060/6080 stops in
regular intervals (approx. every 10
minutes) and runs hot.
(3) The running noise is too loud.
(4) The pump furs after a short period
of time (approx. 2 to 3 months).
54
Cause
(a)After a longer stop period, deposits
have „stuck up" the bearing sections
of the pump.
(b)Motor sections, such as bearings or
the motor block, are defective.
The motor block is defective; the inner
thermostat is triggered; otherwise no
mechanical defect can be detected.
(a)Dirt particles in the inside of the
motor.
(b)Parts of the bearing have worn after
a longer period of operation.
Excessively high lime additions due to
oversaturated salt water, for example,
cause lime deposits on the bearing
parts.
Remedy
(a)Disassemble and clean the pump.
-> Disassembling the pump
(b)Disassemble and clean the pump.
Check the parts or take them to a
repair service.
(b)Replace the motor block.
(a)Disassemble and clean the pump.
(b)Disassemble and clean the pump.
Check the parts or take them to a
repair service, or send them to Tunze
Reduce the lime additive or submerge
the pump in a 10 l (2.6 gal.) bucket,
half full with water and 20 ml (.04 pt) of
vinegar essence. Permit the pump to
run for one to two hours. Avoid
splashes! Subsequently, thoroughly
rinse in tap water.
® .