cecotec CREMMAET COMPACTCCINO CONNECTED Bedienungsanleitung Seite 53

5. Coffee waste tank
Fig. 18 and 19
When the indicator light for accumulation of dregs in waste tank lights up, the waste tank is
not properly positioned or installed, or it is full and needs to be emptied. Empty the waste tank
every 5 cups of coffee.
6. Descaling
Fig. 21
The machine may warn you that descaling is necessary. Refer to the "Descaling" subtitle in the
"Cleaning and maintenance" section.
7. Warning of water shortage in the internal pipeline.
The coffee machine may warn you that there is a lack of water in the internal piping. Make
sure that there is water in the tank and that it is properly installed. Try activating the pump by
making some coffee to activate the pump so that it sucks water. If the error persists, perform
a couple of descaling cycles.
4. CLEANING AND MAINTENANCE
Cleaning/rinse
1. Adjust the height of the coffee spout and place a cup underneath.
2. Touch the RINSING button that appears within the configuration menu.
NOTE: Perform this process until the water comes out clean.
How to dismantle the parts for cleaning
Figure 4
1. Pull the water tank upwards by grasping it at the back and guide it out.
2. Pull the right side cover until it is removed.
3. Press where the blue arrow indicates at number 3 and pull the brew unit outwards for
cleaning.
4. The drip tray can be removed for cleaning by pulling it out. You will see the coffee dregs and
all the coffee residues that have accumulated over time. You can use the plastic brush to
clean everything. Afterwards, dry it before replacing it.
ATTENTION: When reinstalling the brew unit, a snapping noise will be heard and the brew unit
will be fixed; if you do not hear it, disassemble the brew unit again and reinsert it.
ATTENTION: Check whether the water tank is at the same level as the top of the appliance, so
that it is positioned correctly. If this is not the case, push the water tank down until it clicks
into place.
CREMMAET COMPACTCCINO CONNECTED
ENGLISH
53