The On/Off Trigger Switch - Vevor Dc180 Handbuch

combination of personal protection and
visibility of cutting area.
• Loosen the wheel gard locking knob and
rotate the guard to the required
position.(FIG.6)
• Securely tighten the wheel guard locking knob
to lock the guard in place.
Note: the tightness of this locking knob and the
security of the wheel guard should be
checked regularly when operations
commence.

THE ON/OFF TRIGGER SWITCH

This machine is equipped with a safety start
trigger switch.
To start the tool:
• Push in the safety lock button (Fig.5a) on the
side of the handle with your thumb.
• Depress the main trigger switch (Fig.5b) to start
the motor.
WARNING: Never start the saw with the cutting
edge of the saw blade in contact with the
workpiece surface.
CUTTING ADVICE
PRE-CUTTING ADVICE
• Ensure that the power supply matches the
requirements specified on the matches the
requirements specified on the machines rating
plate.
• Ensure that the machine trigger switch is in the
"OFF" position. If the machine is connected to a
power source with trigger switch the "ON"position
, the machine could start operating immediately
with the possibility of a
serious accident occurring.
• If an extension cable is required it must be a
suitable type for use outdoors and so labeled.
• The manufacturers instructions should be
followed when using an extension cable.
• Route any extension cable so that it does not
pose a trip (or any other ) hazard to the operator
to any bystanders.
- 12 -