Handicare RoMedic EasyGlide Gebrauchsanweisung Seite 5

Transfer from bed to bed
Material:
Polyethen
Care of the product:
Clean EasyGlide with water or disinfectant.
SystemRoMedic
M A N U A L
TM
The EasyGlide is placed under the hips and shoulders.
The patient is turned on one side. A draw sheet can be used to facilitate the
transfer. Guide the EasyGlide in under the patient, between the bed sheet and
the draw sheet. Press the EasyGlide down into the mattress somewhat and
push in.
Ensure that the weight of the hips and shoulders is centred on the EasyGlide.
Transfer on transfer slide. Place the transfer slide between the two underlying
surfaces. By using a draw sheet, the caregiver's reach is extended, allowing a
better working stance.
Make sure the transfer slide is between the two underlying surfaces and that
the gap between the beds does not exceed 15 cm/6 inch. Lean the patient
towards the transfer slide and pull the draw sheet to transfer the patient.
To remove, lean the patient to one side and pull out the EasyGlide.
The product meets the requirements of the Medical Devices
Directive 93/42/EEC.
Contact your local distributor if you have any questions
about the product and its use. See www.handicare.com
for a complete list of distributors. Always make sure that
you have the right version of the manual. The most recent
editions of manuals are available for downloading from our
website, www.handicare.com.
Medical Device Class I
English
5