cecotec POWER ESPRESSO 20 PRO LATTE Bedienungsanleitung Seite 43

4. Next, insert the portafilter into the appliance head and turn it until it clicks into position.
The portafilter arm must be aligned with the locking position
5. Plug the coffee machine into a mains socket and press the power button
the corresponding indicator light will turn on and the appliance will start preheating
automatically.
6. During the preheating process, the coffee button indicator light
the steam knob is in the OFF position. If it is not, all three indicator lights will start flashing
at the same time and the appliance will not start.
7. When the coffee indicator light
to dispense hot water and clean the filter or cup, if desired.
Preparing espresso coffee
1. While the appliance is preheating, fill the filter with ground coffee (neither too coarse nor
too fine) using the measuring spoon, then compress it with the tamper part. Fig. 4
2. Clean any coffee residue from the edge of the portafilter with a brush or by hand.
3. Use one of the filters depending on the amount of coffee you want to prepare. For one
coffee, use the single-cup filter, for two coffees, use the double-cup filter.
4. Insert the portafilter into the appliance head and turn it to the locking position
5. After that, place a cup under the coffee spout.
6. When the coffee button indicator light
to brew coffee. Adjust the position of the cup under the portafilter to ensure that the coffee
drips into the cup.
7. If you need to brew more coffee, press the coffee button
8. The brewing process is finished when no more coffee comes out.
Milk frothing function
1. To froth the milk, first press the power button
the steam button
remain steady until the preheating process has been completed.
2. Fill a jug or cup one-third full with cold milk.
3. Then, place the steamer just below the surface of the milk and push it slightly into the milk
until it is in contact with the milk (about 1 cm deep).
4. Finally, turn the steam knob slowly until steam starts coming out of the steamer. Fig. 6.
Note: the steam flow can be adjusted according to your preferences. Allow the steamer to emit
a little water or steam before frothing the milk.
5. Once the milk has reached a temperature of about 75 °C and a layer of froth starts to form,
slowly turn the steam knob to the OFF position and press the steam button
steam output.
Hot water function
1. When the power indicator light
remains steady, turn the steam knob to the ON position
. The corresponding indicator light will start flashing and will not
lights up, press the coffee button
remains steady, press the corresponding button
again.
to switch on the machine and then press
POWER ESPRESSO 20 PRO LATTE
ENGLISH
. Fig. 5
will flash. Make sure
. Fig. 5
to stop the
and then turn the
. Next,
43