cecotec POWER ESPRESSO 20 PRO LATTE Bedienungsanleitung Seite 42

ENGLISH
Box content
Espresso coffee machine
-
Measuring spoon with tamper
-
Portafilter handle
-
Single-cup filter
-
Double-cup filter
-
Milk tank
-
Instruction manual
-
First cleaning
Warning: clean the coffee machine before using it for the first time to remove all possible
manufacturing residues.
1. Pour water into the water tank, do not exceed the "MAX" mark, and place the water tank in
its correct position.
2. Insert the portafilter and filter (empty) in their position.
3. Place a cup on the cup/mug tray. Make sure the steam knob is in the off position.
4. Connect the machine to the mains and press the power button. The red indicator light will
light up indicating the machine is preheating.
5. Press the coffee button for the pump to start pumping water.
To stop this process, press the button again.
-
The indicator light will light up when the preheating process is finished.
-
6. Once the machine has finished dispensing water, throw away the remaining water and
clean all containers thoroughly.
7. Now, the machine is ready to be used.
Warning: when activating the pump for the first time, the appliance may make some noises
which will
disappear after 20 seconds. This is because the appliance is releasing air and is completely
normal, it does not affect the operation.
3. OPERATION
1. Fill the water tank with water, up to the MAX mark. Place the water tank upright so that the
tabs are correctly aligned with the slots at the back of the appliance, then push it down
until it clicks into place.
2. Put one of the filters into the portafilter making sure that the slots on both accessories
match. Fig. 3
3. Fill the filter with ground coffee and press it with the measuring spoon with presser. Fig. 4
42
POWER ESPRESSO 20 PRO LATTE