Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4
Preparing for operation and settings
4.1
Battery
For detailed information, see the separately enclosed operating instructions for the battery and the
charger.
WARNING
Exclusively use Bosch-ProCORE batteries and chargers as described in this manual
(Section 3.3). Use of other batteries/chargers can result in injury or fire. To avoid the risk of
personal injury or fire, read the battery charger operating instructions prior using the charger
and battery.
4.1.1
Charging the battery
► Connect charger to mains.
–
Green LED illuminates (charger ready for
use).
► Insert battery in charger.
–
Green LED flashes: Battery is being
charged.
–
Green LED illuminates continuously:
Battery is fully charged.
–
Red LED illuminates continuously: Battery
temperature outside charge-temperature
range.
–
Red LED flashes: see operating instruc-
tions of charger.
●
Charging time: Charging of empty battery: 4 Ah: 30 min. = approx. 80%, 50 min. = approx. 100%
charging capacity, 8 Ah: 70 min. = approx. 80%, 80 min. = approx. 100% charging capacity.
●
Ideal battery temperature during charging process: 15–40 °C (59–104 °F)
●
Avoid battery temperatures below 0 °C (32 °F) and over +45 °C (113 °F) during the charging process.
●
The battery can be charged at any time, regardless of the charge status.
4.1.2
Inserting/removing battery in/from tool
► Inserting the battery: Insert the charged battery into the tool. The unlock button must engage in the
second step (in the first step the battery is held in place in the tool, but without electrical contact).
–
The display on the operating panel illuminates.
●
If the tool is not used for approx. two minutes the display changes into sleep mode. Cancelling sleep
mode: Lift operating lever.
●
If the tool is not used for a long period (days) the battery must be removed from the tool and charged/
stored in the battery charger.
► Removing the battery: Press the unlock button and remove the battery at the same time.
4.1.3
Checking the charge status
► LED display "Battery charge status" on oper-
ating panel, with battery inserted:
–
The charge status is shown in % and by a
progress bar (1)
–
Below 10% minimum charge (battery must
soon be charged)
–
The information symbols (2) only appear if
a corresponding situation is occuring (Section 6.7).
36 of 50
2
SIGNODE BPT-H32
1
V 11.21_EN
Werbung
