Renogy ROVER Serie Installation Und Handbuch Seite 3

Battery Safety
Use only sealed lead-acid, flooded, gel or lithium batteries which must
Explosive battery gases
ventilation to release the gases.
Be careful when working
fresh water available in case there is contact with the battery acid
Carefully read battery
Do NOT let the positive (+) and negative (-) terminals of the battery touch each other.
Recycle battery when it is replaced
Over-charging and excessive gas precipitation
activate material shedding
may cause damage. Please carefully review the specific requirements of the battery
used in the system
Equalization is carried
batteries.
Do NOT equalize VRLA type AGM / Gel / Lithium cell batteries UNLESS permitted by
battery manufacturer.
Default charging parameters
Phosphate (LFP) Battery only. Before using Rover to charge other types of lithium
battery, set the parameters
Connect battery terminals to the charge controller BEFORE connecting
the solar panel(s) to the charge controller. NEVER connect solar panels to
charge controller
Do NOT connect any inverters or battery charger into the load terminal of
the charge controller.
Once equalization is active in the battery charging, it will not exit this stage
unless there is adequate charging current from the solar panel. There
should be NO load on the batteries when in equalization charging stage
may be present
with large lead acid batteries.
manuals before operation
on them. Too high of an equalizing
out only for non-sealed
in Li mode
according to the suggestions
until the battery is connected
while charging. Be certain
Wear eye protection
may damage the battery plates and
/ vented/ flooded
are programmed
from battery
be deep cycle.
there is enough
and have
charge or too long of one
/ wet cell lead acid
for 12.8V Lithium
manufacturer.
Iron
02