Renogy ROVER Serie Installation Und Handbuch Seite 26

PV indicator
Off during daylight
BATT Indicator
White Slow Flashing
White Fast Flashing
Load Indicator
White Fast Flashing
Error Indicator
WhiteSolid
25
System Status
Ensure that the PV wires are correctly and tightly secured inside
the charge controller PV terminals. Use a multi-meter to make
sure the poles are correctly connected
Disconnect loads, if any, and let the PV modules charge the battery
bank. Use a multi-meter to frequently check on any change in battery
voltage to see if condition improves. This should ensure a fast charge.
Otherwise, monitor the system and check to see if system improves.
Using a multimeter
exceeding 32 volts.
The Load
overloaded.
the controller and make sure it does not exceed 20A (DC)
System Error. Please check LCD for Error code
Error Number
E2
EIO
Troubleshooting
Troubleshoot
Troubleshoot
check the battery voltage and verify it is not
Troubleshoot
circuit on the
Please ensure the device is properly
Troubleshoot
Error Codes
to the charge controller.
controller is being
Description
No error detected
Battery over-discharged
Bagery_
Load short circuit
Load overloaded
Gontroller over-tempere!yre
PV over-voltage
shorted or
connected to
EN