Renogy ROVER Serie Installation Und Handbuch Seite 21

ENTER/
Programming Parameters
Battery type
Over-discharge
To enter the programming interface simply press and hold the right arrow button. After entering
this feature press the Enter/Right
parameters, press
Enter/Right button
The charging parameter
over-discharge return voltage, Over-discharge voltage) are only available under the battery
"USER" mode. Press and hold the right arrow to enter the programming
pressing the right arrow button until you see the desired voltage screen
NOTE
Battery charging parameters can also be programmed using the Renogy BT APP. Read the
corresponding user manuals for more information.
-5
System voltage
Over-discharge
voltage
t 1.1—1
button
the Up or Down button.
setting (Equalizing
Page Up/ Increase parameter value
Page Down/ Decrease parameter value
Return to the previous menu
Enter sub menu/ save parameter
turn load
Equalizing voltage
:s.s
0
return voltage
0
to switch between
To save the parameter
voltage, Boost voltage,
on or off in manual
Boost voltage
Float voltage
{3.8 v
parameters. To change
press and hold the
Floating charging
settings and continue
value/
mode
the
voltage,
20