Renogy ROVER Serie Installation Und Handbuch Seite 8

The charge controller will reduce the voltage charge to smaller quantity, while lightly charging
the battery. The purpose
battery storage capacity. In the event that a load drawn from the battery exceeds the charge
current, the controller will no longer be able to maintain the battery to a Float set point and the
controller will end the float charge stage and refer back to bulk charging
Equalization:
the battery for a controlled period of time. Certain types of batteries benefit from periodic
equalizing
chemical reaction. Equalizing
complement voltage, which gasifies the battery electrolyte.
Once equalization is active in the battery charging, it will not exit this stage unless
there is adequate charging current from the solar panel. There should be NO load
on the batteries when in equalization
Over-charging and excessive gas precipitation may damage the battery plates
and activate material shedding on them. Too high of equalizing
long may cause damage. Please carefully review the specific requirements of the
battery used in the system
Equalization
WARNING
loads. Ensure that all load allowable input voltages are greater than the equalizing
charging set point voltage.
Lithium Battery
The Rover MPPT charge
battery. The protection circuit of lithium battery will typically turn the battery off and make it
unusable if over-discharged.
discharged state for any length of time as self-discharge would gradually deplete the remaining
charge. Without the wake-up feature to reactivate and recharge batteries, these batteries would
become unserviceable
current to activate the protection circuit and if a correct cell voltage can be reached, it starts a
normal charge.
( CAUTIO N
When using the
voltage to 24V instead
selected the
activation. In the
trigger the system
Up or Down buttons
07
for this is to offset the power consumption
Is carried out every 28 days of the month. It is intentional
charge, which can stir the electrolyte,
charge increases the battery voltage, higher than the standard
may increase
Activation
controller
This can happen
and the packs would be discarded.
Rover to charge
of auto
Rover will allow
activation
voltage selector.
then long
charging stage.
battery voltage to a level damaging
has a reactivation
when
a 24V lithium
recognition. If auto
you to change it to 24V when
interface press
To change
press Enter to save
while maintaining
balance battery voltage
feature to awaken
storing a lithium
The Rover will apply a small charge
battery bank,
recognition
the
and hold the enter
the system voltage,
the selected
a full
overcharging of
and complete
charge or for too
to sensitive DC
a sleeping lithium
battery pack in a
set the system
is accidently
lithium battery
button to
press the
system voltage.
EN