AWG S2/M2 Originalbetriebsanleitung Seite 37

AWG | Fittings | Adjustable foam nozzles S2 / M2 and S4 / M4
4. Insert the new conversion screen into the foam tube, rotating the con-
version screen in such a way that the threaded holes on the conver-
sion screen are accessible through the bores on the foam tube.
5. Screw the conversion screen back on.
Replacing the handle
1. Unscrew the cylinder head screws (Fig. 3/7).
2. Remove the handle (Fig. 3/6) from the foam tube.
3. Insert the cylinder head screws and the discs (Fig. 3/8) into the new
handle.
4. Place the handle in the correct position on the internal thread screws
(Fig. 3/9) and screw tight.
Replacing the hand lever
1. Unscrew the screw (Fig. 3/3).
2. Remove the hand lever from the shut-off valve.
3. Clean the shut-off valve.
4. Insert the screw and the disc (Fig. 3/2) into the new hand lever.
5. Place the hand lever in the correct position on the shut-off valve and
screw tight.
Replacing the protection ring on the foam tube
The protection ring is fastened with studs, which are inserted into bores
on the foam tube and additionally glued to the foam tube.
1. Lever the protection ring with studs out of the bores, and pull the pro-
tection ring (Fig. 3/5) off the foam tube.
2. Clean the foam tube.
3. Apply onto the new protection ring an adhesive suitable for NBR and
position the protection ring on the foam tube, making sure that the
studs snap into the bores on the foam tube.
37
MAiNTENANCE
M1108B10 | Rev. 03-08/24