AWG Z2 Originalbetriebsanleitung Seite 38

AWG | Fittings | Inductors Z2, Z4 and Z8
7 Maintenance
7 .1 Inspection and maintenance
Apart from the visual inspection and cleaning of the AWG Inductors, no
regular maintenance work is required.
7 .2 Repair
Any repair work on the AWG Inductors may only be performed by the AWG
Fittings GmbH customer service or by an authorised specialist workshop.
If you need technical support, please contact our Service Centre:
AWG Fittings GmbH
Service Centre
D-89177 Ballendorf
Telephone: +49 (0) 73 40 / 91 88 98 880
Email: awg-service@idexcorp.com
We will accept devices in need of repair or maintenance, discuss with you
the quickest and cheapest solution, create cost estimates, take care of the
execution of the repair work and are at your disposal for any questions.
7 .3 Disposal
Observe the local regulations regarding proper waste recycling or disposal.
Materials
Body:
Tube, flange:
Nozzle body, setting sleeve:
Seals:
Storz adapters:
M1061B10 | Rev. 03-08/24
Type 'L'
Polyoxymethylen
(POM) plastic
Cast aluminium,
powder-coated in red
Aluminium, black anodised
Aluminium anodised
maintEnancE
Type 'S'
Cast copper alloy
Aluminium,
anodised
NBR
38