AWG Z2 Originalbetriebsanleitung Seite 21

AWG | Fittings | Inductors Z2, Z4 and Z8
FOREWORD
Applicable standards and regulations
The design and construction of the AWG Inductors Z2, Z4 and Z8, Types
L 'Leicht' and S 'Schwer' [Light and Heavy, respectivly] was carried out
in accordance with the relevant provisions laid down by these directives
and the harmonised standards:
>
DIN 14384:2011-01 Schaummittel-Zumischer PN 16, selbstansaugend
[Inductor proportioner PN 16 for foam compound]
Conversions and modifications
Unauthorised conversions or modifications to the inductors are pro hibited
without written consent from the manufacturer.
AWG Fittings GmbH accepts no liability for damage caused by conversions
or modifications, improper handling by the customer or by third parties
commissioned by the customer, or caused by non-compliance with these
instructions.
Applicable Documents
Apart from this manual, no other applicable documents are required for
the safe handling of the AWG Inductors.
The data sheet for this device can be downloaded from our website: www.
awg-fittings.com
Copyright
This operating manual is valid for the devices
AWG Inductors Z2, Z4 and Z8, Types L 'Leicht' and S 'Schwer'
[Light and Heavy, respectively]
© AWG Fittings GmbH Revision: 03 of 14/08/2024
All rights to this document are reserved by AWG Fittings GmbH.
The document may not be copied or reproduced in whole or in part without
the written permission of AWG Fittings GmbH. The document is intended
for persons using the device described and must not be passed on to
third parties.
Subject to technical changes and errors.
These instructions and the applicable documents are not subject to any
automatic change service. The latest version can be obtained from the
manufacturer.
21
M1061B10 | Rev. 03-08/24