AWG Z2 Originalbetriebsanleitung Seite 25

AWG | Fittings | Inductors Z2, Z4 and Z8
2 Safety information
The AWG Inductors Z2, Z4 and Z8 are in line with the state of the art as
well as the recognised safety regulations. The safety and health protection
requirements have been met. Nevertheless, their use may give rise to
hazards for the user or third parties or cause damage to the device itself
or other material assets.
2 .1 General safety notes
>
The device may only be operated in accordance with these instructions
and in perfect condition.
>
The operators must have received the necessary training to be able
to handle the device properly.
>
Unauthorized modifications or the installation of additional components
not approved by the manufacturer endanger the proper functioning of
the device.
– Modifications to the device are prohibited
– Only use accessories approved by the manufacturer
>
The operator is responsible for safety in the vicinity of the device, in
particular for compliance with the general safety regulations. This in-
cludes ensuring, before switching on the entire extinguishing system,
that all protective devices are fully in place and functional.
2 .2 Safety during operation
>
Observe all safety rules and protective measures applicable for use
at the place of use.
>
Make sure the device does not get damaged during transport, instal-
lation, commissioning, operation or maintenance.
>
The safety regulations laid down in the country-specific service regulati-
ons for firefighters (for example in Germany the Feuerwehr dienstvorschrift
FwDV) or the corresponding internal company regulations must be
observed.
25
SafEty information
M1061B10 | Rev. 03-08/24