Ayce MJ10250VIIIC Originalbetriebsanleitung Seite 97

i. Changing the blade depth (Fig. 18)
The saw blade depth should be set so that the outer points of the saw blade are
higher than the work piece by approximately 1/8" (3.2 mm) to 1/4" (6.4 mm), but the
lowest points (gullets) are below the top surface.
Fig. 18 Fig. 18
Gullet Gullet
! It is not necessary to loosen the blade bevel lock knob when raising or
lowering the saw blade.
WARNING
j. Changing the blade angle (Fig. 19)
Fig. 19
Height/bevel
Blade bevel
adjusting
lock knob
90°
handwheel
45° 45°
• Unplug the saw.
• Turn the blade bevel lock knob clockwise
to tighten it securely.
• Raise the blade by turning the height
adjusting handle clockwise, or lower it
by turning the handle counterclockwise.
• Unplug the saw.
• Loosen the blade bevel lock knob by
turning it counterclockwise.
• To adjust the bevel angle, turning the
height/bevel adjusting handwheel
counterclockwise increases the angle
of the blade, bringing it closer to 45°;
Turning it clockwise decreases the
angle, bringing the blade closer to 90°.
• To lock by turning the blade bevel lock
knob clockwise.
k. To assembly the side extension table (Fig. 20-21)
Fig. 20
Fig. 21
192 | 193
• Sliding the tubes into the two holes at
the side of the main table.
• Fix the screws M4 x 10 into the holes
at the end of both extension tubes to
prevent the side table from being pulled
out too far.
• You can lock at the desired position with
the two locking knobs at the bottom of
the main table.
GB