Ayce MJ10250VIIIC Originalbetriebsanleitung Seite 96

Fig. 13
90° Set screw 90° Set screw
45° Set screw 45° Set screw
Fig. 14
Square
Fig. 15
Triangle square Triangle square
• Unplug the saw.
• Raise the blade to the maximum height
by turning the high adjusting handle
clockwise.
• Using a square, set the blade to exactly
90°. (Fig. 13)
• If the blade stops bevelling before it
gets to 90°, loosen the stop screw
(located in the left of the table insert)
(Fig. 14) with the 5 mm hex key (not
included), and then adjust it to 90°.
• With the blade set at 90°, slowly turn
the 90°-stop set screw until you feel
resistance. Bevel the blade away from
90° a little, and then back to the stop.
• Re-measure the angle, and repeat the
stop adjustment as necessary until the
blade stops at 90°.
• Set the 45° stop in the same way. The
set screw for the 45° stop is located in
the right of table insert.
h. To assemble the blade guard (Fig. 16-17)
! The saw blade guard must be in position at all times to prevent
contact with the blade. It should lift up and onto the work piece when
the work piece is passed through the saw.
WARNING
Fig. 16
Fig. 17
! The blade guard should return to its rest position after the work piece
has been cut.
WARNING
190 | 191
• Attach the blade guard over the riving
knife so that the hole in the guard and
the hole in the riving knife are aligned.
• Insert the screw M6 x45 and fit the flat
washer 6 and hex nut M6.
• Tighten the hex nut sufficiently so that
the guard rests on the table top but will
lift when the work piece is pushed into
the table.
• Blade guard in place as shown in
Fig. 17.
GB