Ayce MJ10250VIIIC Originalbetriebsanleitung Seite 103

stick should be used in place of the user's hand to guide the material between the
fence and blade. When using a push stick, the trailing end of the board must be
square. A push stick against an uneven end could slip off or push the work piece
away from the fence.
! Do not locate the push-stick to the rear of the work piece, Kickback
can result from the push-stick pinching the work piece and binding
the blade in the saw kerf if positioned improperly. It may cause
serious personal injury.
WARNING
u. ON/OFF paddle switch (Fig. 39)
Fig. 39 Green I-push
button
Yellow safety flap
Red EMERGENCY Red O-push
OFF button button
v. Overload protection (Fig. 40)
Fig. 40 Fig. 40
Reset overload Reset overload
relay button relay button
Switching On
• Push the red EMERGENCY OFF button
upward and open the yellow safety flap.
• To start the operation, press the green
I-push button.
• Afterwards, close the safety flap without
engaging it.
Switching Off
• Press the red EMERGENCY OFF button
or the red O-push button.
• This saw is equipped with a reset
overload relay button. It is situated at
the immediate right of the paddle switch.
The reset button will restart the motor
after it shuts off due to overloading or
low voltage.
If the motor stops during operation,
move the ON/OFF paddle switch to the
OFF position. Wait approximately five
minutes for the motor to cool down and
push the reset button. Now you can
switch to the ON position again.
! In order to avoid injury and prevent accidental start-up when the
reset button is pushed, the on/off paddle switch should be in the off
position, and the power cord should be unplugged from the outlet
while the saw is cooling down. Overheating may be caused by an
WARNING under-sized extension cord, an extension cord that is too long,
misaligned parts, or a dull blade. inspect the saw for proper set-up
before using it again.
w. Using the extension table (Fig. 41)
Fig. 41
Auxiliary aluminum
fence
Locking knob
204 | 205
• Unlock the extension table locking knob
underneath the main table.
• Slide the extension tubes in or out until
the scale on the tube is positioned at
the desired distance. Lock the extension
table locking knob.
• To adjust the position of the rip fence,
loosen the locking handle, and place
the auxiliary aluminum fence in position
by using the calibration point in red.
• Tighten the locking handle.
GB