Ayce MJ10250VIIIC Originalbetriebsanleitung Seite 101

s. To close the stand and move the saw (Fig. 34-37)
• Remove any work pieces from the tool.
• Remove and securely store any tools or accessories such as rip fence, miter gauge,
push stick, etc.
To close the stand:
Fig. 34 Fig. 34
Fig. 35 Fig. 35
• At the same time, grasp the handle,
step on the release lever, and lift up on
the handle.
• Continue to grasp handle and allow
weight of saw to rotate saw down until
release lever clicks and locks into place.
To move the leg stand:
Fig. 36 Fig. 36
Fig. 37 Fig. 37
200 | 201
• Grasping the handle firmly, place foot
on axle bar for leverage, and pull handle
back towards you until the stand is
balanced on the wheels.
• Grasping the handle firmly, place foot
on axle bar for leverage, and pull handle
back towards you until the stand is
balanced on the wheels.
GB