Ayce MJ10250VIIIC Originalbetriebsanleitung Seite 105

aa. Crosscutting (Fig. 44-45)
Fig. 44
Transport lock
Locking knob
Fig. 45
! In order to avoid instability, always place the larger surface of the
work piece on the table when crosscutting and/or bevel crosscutting.
WARNING
• First unlock the sliding table by moving
the transport lock and loosening the
locking knob below the table. (Fig. 44)
• Remove the rip fence and place the
miter gauge in the miter gauge groove
on the table.
• Raise the blade until it is approximately
1/8" (3.2 mm) above the top of the work
piece.
• Hold the work piece firmly against the
miter gauge, with the path of the blade
in line with the desired cutting line.
Move the work piece to within 1" (2.5 cm)
of the blade.
• Start the saw, and wait for the blade to
reach full speed. Do not stand directly
in line with the saw blade's path. Instead,
stand on the side where the cut is being
made.
• Keep the work piece against the face
of the miter gauge and flat against the
table. Slowly push the sliding table with
the work piece through the blade.
• Do not attempt to pull the work piece
backward while the blade is turning.
Turn the switch OFF, and wait until the
blade has come to a complete stop
before carefully sliding the work piece
out.
bb. Bevel crosscutting 0° - 45° blade bevel & 90° miter angle (Fig. 46)
This operation is the same as crosscutting, except that the blade is at a bevel angle
other than 0°.
Fig. 46 Fig. 40
cc. Compound miter crosscutting 0° - 45° blade bevel & 0° - 45° miter angle
(Fig. 47)
This sawing operation combines a miter angle with a bevel angle.
Fig. 47 Fig. 40
208 | 209
• Adjust the blade to the desired angle,
and then tighten the blade bevel locking
knob.
• Tighten the miter locking handle at 90°.
• Hold the work piece firmly against the
face of the miter gauge throughout the
cutting operation.
• Set the miter gauge to the desired
angle.
• Set the blade bevel to the desired bevel
angle, and tighten the blade bevel locking
knob.
• Hold the work piece firmly against the
face of the miter gauge throughout the
cutting operation.
GB