Ayce MJ10250VIIIC Originalbetriebsanleitung Seite 93

ASSEMBLY AND ADJUSTMENT
! Do not connect the plug to the outlet until all installations and
adjustments have been completed and you have read and understood
the safety and operational instructions.
WARNING
a. Assemble the stand (Fig. 1-2)
Fig. 1
1
14
13
7 8 6
9
11
2
12
10
3
4
5
16
17
16
17
10
12
11
13 15
14
• Group the leg stand parts by type and
size and correct quantities.
• Attach the tubes of the stand support
(1) with the corresponding tubes of the
stand assembly (2) and align the holes.
• Insert the M8 x 75 socket head bolt (3)
on the leveling foot (4) assembly into
the hole (with a M8 hex nut welded on
it) and tighten the bolt (3) with 6 mm hex
wrench (supplied).
Secure the locking knob (5) by turning
it clockwise.
• Secure the shock absorption pad (6)
with a M8 x 60 hex bolt (7) and a M8
flat washer (8) on the other hole.
Tighten the locking knob (9) clockwise.
• Slide one M10 big flat washer (10),
roller sleeve (11), wheel (12) and M8
big flat washer (13) and M8 hex nut (14)
on the axle through the hole in the
center of the wheel (12).
Secure in place using the adjustable
wrench or 13 mm wrench (not supplied).
Repeat with the second wheel (12).
• Attach the handle assembly (15) to leg
stand assembly (2) with two M6 x 35
socket head bolts (16) and M6 hex nuts
(17) as shown in Figure 1.
Fig. 2
! Be sure that the leg stand is securely locked in an open position
and that the shock absorption pad stabilized the table saw before
operation.
WARNING
b. Remove the protective foam (Fig. 3-4)
! Before using this saw, you are required to remove the protective
foam around the motor and the blade as follows.
WARNING
Fig. 3
Cross-screws
184 | 185
• Figure 2 is complete open leg stand
assembly.
• Unscrew the six cross-screws with
the screwdriver (not supplied) on the
bottom panel under the saw and remove
the bottom panel. (Fig. 3)
GB