Trouble Shooting - Parkside Performance Ppfsa 40-Li A1 Originalbetriebsanleitung

Trouble shooting

In the event of an accident or malfunction, remove the battery from the device im-
mediately! Failure to comply may result in injuries from cuts.
Problem Possible cause
Battery (20) discharged
Appliance
Battery (20) not in
won't start
On/Off switch (10) defective
Motor defective
Internal loose contact
Intermittent
operation
On/Off switch (10) defective
Much
Trimming assembly dirty
vibration
Loud noise
Motor defective
The line spool (33) does not
have enough cutting line
Both or one of the cutting line
is not protruding out of the
Bad trim
spool (15)
Trimming assembly dirty
Battery (20) not fully charged
Corrective action
Recharge battery (20) (Observe the
separate operating instructions for the
rechargeable battery and charger)
Insert battery (20) (Observe the separate
operating instructions for the rechargea-
ble battery and charger)
Send in to Service Centre for repair
Send in to Service Centre for repair
Clean trimming assembly
(see „Cleaning and maintenance")
Send in to Service Centre for repair
If necessary, extend the cutting line (see
chapter "Device adjustments")
Replace the spool (see "Cleaning and
Maintenance").
Remove the spool and feed the cutting
line through the openings to the outside,
then reinstall the spool.
Clean trimming assembly (see „Cleaning
and maintenance")
Recharge battery (20) (Observe the
separate operating instructions for the
rechargeable battery and charger)
GB IE
51