Technical Data - Parkside Performance Ppfsa 40-Li A1 Originalbetriebsanleitung

GB IE
23 Mounting screw
24 Lock
25 Screw
26 Line cutter
27 Shaft mount
28 Receptor
29 Handle mount
30 Star screw
31 Uptake spindle
32 Line outlet loop
33 Spool
34 Groove
35 Washer
36 Clamping disk
37 Nut
38 Click lock

Technical data

40V Cordless
brush-cutter ............PPFSA 40-Li A1
Motor voltage U ........... 40 V
Idle speed spindle n
3 steps ............4600/5500/7000 min
Motor Idle speed .....................3100 min
Weight (without cutting tool) ...........4,9 kg
Spool
Cutting circle .......................... 340 mm
Line thickness ........................... 2.4 mm
Line length ....................................5 m
Thread ........................................ M10
Vibration (a ) at the handle
h
right ...............2,379 m/s
left .................2,051 m/s
2-tooth blade
Cutting circle .......................... 255 mm
Borehole ............................... 25.4 mm
Vibration (a ) at the handle
h
right ............. 3,668 m/s2; K=1,5 m/s2
left ............... 2,224 m/s2; K=1,5 m/s2
Weight (operationally ready) ..........5.9 kg
Sound pressure level
(L ) ................... 68,0 dB(A); K
pA
32
; (2 x 20V)
.............7000 min
max
; K=1,5 m/s
2
; K=1,5 m/s
2
= 3 dB
pA
Sound power level (L
guaranteed ........................... 90 dB(A)
measured ..... 88,0 dB(A); K
Temperature...........................max. 50 °C
Charging process ...................4 - 40 °C
Operation .......................... -20 - 50 °C
Storage .................................0 - 45 °C
Levels of noise and vibration were deter-
mined according to the standards and
regulations in the declaration of conform-
ity. Vibration and noise tests have been
carried out successfully in accordance with
EN 50636-2-91.
Noise and vibration values have been
determined according to the standards and
regulations mentioned in the declaration of
conformity.
The stated vibration emission value was
measured in accordance with a standard
-1 testing procedure and may be used to com-
pare one power tool to another.
-1
-1 The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
which the power tool is used.
2
Try to keep the exposure to vibra-
2
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched
off and times when it is switched on
but running without any load).
)
WA
= 1,91 dB
WA