Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8
9
10
11
12
13
14
15
16
17
18
Defines pre-flashing modes of FLASH, IND/ELEC
and LED outputs if FLASH SETUP = 0/1
0 = pre-flashing before each opening manoeuvre
1 = pre-flashing before each opening manoeuvre
2 = pre-flashing before each closing manoeuvre
ATTENTION !
pre-flashes on opening only; LED output (red light)
pre-flashes on closing only
Defines the duration of the pre-flashing
tP.r.
ATTENTION !
performed
Enables the "man present" function on SBS, OPEN
and CLOSE inputs
de.a.
ATTENTION !
the operation of the remote controls is inhibited
Defines the behaviour of the IND/ELEC and LED
outputs (barrier lights)
5 = MODE 1
• barrier closed, LED output active (red LEDs)
• barrier open, IND/ELEC (green LEDs) and
LEDs (red LEDs) outputs not active
• during opening, IND/ELEC output flashing
(green LEDs)
• during closing, LED output flashing
(red LEDs)
IN.D.
• barrier stopped in intermediate position,
LED flashing (red LEDs)
6 = MODE 2
• barrier closed, LED output active (red LEDs)
• barrier open, IND/ELEC outputs active
(green LEDs)
• during opening, IND/ELEC output flashing
(green LEDs)
• during closing, LED output flashing (red LEDs)
• barrier in intermediate position, LED flashing
(red LEDs)
Specifies the number of manoeuvres before the
maintenance request signal (if 0, the function is
disabled).
se.r.
ATTENTION !
output; if closed, it flashes continuously.
Enable maintenance request signalling
se.f.
0 = deactivated
1 = active
Set to 0 if the old CTLIGHT2 module is used
If
the electric lock connected to the IND/ELEC output
EL.T.
If
(in seconds) of the magnetic lock connected to the
IND/ELEC output
If active, maximum acceleration at start-up
ST.P.
0 = deactivated
1 = active
Displays the encoder type in use
En.C.
0 = virtual encoder
1 = physical encoder
Defines the type of automation on which the control
DE.F.
unit is installed and resets the default values.
1 = 3m barrier FAST
iND/ELEC output (green light)
if set to 0, no pre-flashing is
when this function is enabled,
signalling is via the FLASH
= 3; activation time (in seconds) of
= 4; demagnetisation time
0
0
2
0
0
20
0
0
1
6
5
6
x 1000
10
0
200
0
0
1
1
0
1
4
1
10
0
0
1
1
1
1
1
1
1
EN
s
cicli
s
51
Werbung
