6. USER MANUAL VXDSM - VXBHM
DPF1C Desk Panel with display
130
How to vary between standing and sitting while your work
The most important thing is to vary your position and to move around, preferably three times an hour. Instead
of sitting for too long at a time, you can switch between standing and sitting position. Remember good posture
and to stand with your body weight evenly distributed on both legs.
• Start by raising your desk and standing for 15 minutes each hour before you go to lunch.
• Just after lunch, stand for 15 minutes before lowering your desk to sit for 45 minutes.
• Raise your desk again every hour, so that you stand up working for 15 minutes each hour for the rest of the
day.
• Raise your desk before you leave for the day – then it is ready for the next day.
Important reservations when varying between standing and sitting position:
If you are pregnant, have varicose veins or have a health condition that may prevent you from standing for 5-15
minutes at a time every hour, you should contact your doctor to make sure that this will not be detrimental to
your health.
10/38
19
EN 114065
EN
7. OPERATION OF DPF1C
^
= parallel up
^
= parallel down
S
= save
•
= memory 1
••
= memory 2
•••
= memory 3
Up and down (V )
You just either have to activate the up or down button for parallel drive and the system will drive until releasing
the button again or when the system reaches end position.
Memory:
The four small buttons are used for memory drive/storing memory.
Store memory
• Press S – button, the display will fl ash "S" for 2 seconds
• Within these two seconds press one of the small buttons with numbers "1", "2" or "3" and the position
• will be stored at this button.
• The panel will acknowledge by showing "1", "2" or "3" in the display depending on the
chosen position
Memory drive
Press one of the memory buttons and the system will start driving to the pre-programmed memory position.
Keep the button pressed until the position is reached.
Display function
Shows the actual height in either cm or inch and can display error codes.
11/38
EN 114065
EN