Herunterladen Inhalt Inhalt Diese Seite drucken

Bedienung; Operation - LGB Starter Set Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für Starter Set:
Inhaltsverzeichnis

Werbung

6

Bedienung

Schnellstart
Gleise miteinander verbinden. Die Gleise bilden
1
1
einen Kreis (1295 mm Außendurchmesser).
Gleise mit den Gleisklammern befestigen.
2
Darauf achten, daß die Zahl auf der Klammer
nach unten zeigt.
Anschlußkabel mit den Gleisen verbinden.
3
Gleisanschlußklemmen unter den Schienen einhaken
und festschrauben.
Anschlußkabel an den Trafo anschließen. Rotes
4
Kabel mit Klemme 1 und blaues Kabel mit Klemme 2
2
verbinden. Auf die Anschlußklemme drücken.
Kabel in das Loch oben auf der Klemme schieben.
Netzstecker in eine Steckdose stecken.
5
WARNUNG!
Der Trafo darf nur in trockenen Räumen
verwendet werden!

Operation

© DiskArt™ 1988
Quick Start
Connect the tracks. The tracks make a
1
full circle (1295 mm/51 in. outside diameter)
Insert the track clips. Make sure the number
2
on the clip faces down.
Attach the power cable to the track. Hook the track
3
power terminals under the rails and tighten the screws.
Connect the power cable to the power pack.
4
Connect the red wire to Terminal 1. Connect the
blue wire to Terminal 2. Push each terminal inward
slightly. Insert the connecting wire into the hole on
the top of the terminal.
Plug the power pack into a house current outlet.
5
CAUTION!
The power pack is for indoor use only.
Keep it away from moisture.
Utilisation
Pour démarrer rapidement
Raccorder les rails. Les rails forment un cercle
1
complet (1295 mm /51 po de diamètre extérieur).
Insérer les éclisses d'assemblage. Assurez-vous
2
que le numéro sur l'éclisse se trouve vers le sol.
Brancher le câble d'alimentation à la voie. Accrocher
3
les cosses du câble sous les rails et serrer les vis.
Raccorder le câble d'alimentation au groupe
4
d'alimentation. Connecter le fil rouge à la borne 1
et le fil bleu à la borne 2. Pousser chaque cosse
légèrement vers l'intérieur. Insérer le fil de raccordement
dans le trou en haut de la borne.
5
Brancher le groupe d'alimentation dans une prise
de courant dans la maison.
MISE EN GARDE  !
Le groupe d'alimentation ne
doit être utilisé qu'à l'intérieur. Éviter tout contact
avec l'humidité.
5
4
3
7

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis