Medion X50 SW Bedienungsanleitung Seite 213

Fault
There is a position-
ing error.
The fall / anti-drop
sensor
is blocked.
One wheel is
blocked.
The battery is
flat.
The right-hand di-
rection sensor is
blocked or dirty.
The robot vacuum
and mop has been
tilted.
The dust container
or the filters have
been
removed or incor-
rectly
installed.
214
Vocal message
Error 5 :
Device trapped.
Clear the surroun-
ding area.
Error 6:
Anti-drop sensor
blocked, please
wipe.
Error 7 :
Wheel despended.
Please move device
to a new position.
Error 8 :
Low battery.Shut-
ting down device.
Please charge your
device.
Error 12 :
The right alongwall
sensor is blocked.
Please wipe it.
Error 13:
Device tilted. Please
put the device on a
flat surface to start.
Error 14 :
Please install dust
collector and filter.
Possible
cause
Robot vacuum
and mop is not
on level ground
or is incorrectly
positioned.
The robot's wall
sensor is dirty or
blocked.
One of the
wheels is
blocked.
Battery status is
low.
Battery is flat.
Right direction
sensor is dirty.
Robot has been
tilted or is no
longer on a level
surface.
Dust container or
filter has been
removed or in-
correctly in-
stalled.
Solution
 Place the robot
vacuum and mop
back on a level sur-
face or reposition
the robot vacuum
and mop.
 Check your net-
work connection.
 Remove any
dirt or blockages.
 Check the left, right
and front drive
wheel.
 Remove any dirt or
blockages.
 Charge the robot
vacuum and mop
on its charging sta-
tion.
 Check the lateral
direction sensors.
 Please clean the di-
rection sensors.
 Place the robot on
a flat surface to
start it.
 Check that the fil-
ters and dust con-
tainer are correctly
seated.
 Insert the dust con-
tainer and the fil-
ters.