fillikid fill Bedienungsanleitung Seite 14

EN
Installation
Installation with foot
4. insert the locking arms into the ISOFIX
attachment points until you hear an audible "CLICK"
indicating that they are fully engaged and that the
button on either side of the locking arms turns a
green safety colour. 6
Make sure the base is securely installed by pulling
on the two ISOFIX connectors. 5.
5 After placing the base on the vehicle seat, pull the
support leg out to the maximum angle 7 , - 1 and
then pull out the display window completely. 7 - 2
6. press the support leg adjustment knob, 8 -1 hold
the support leg with the other hand and then adjust
the length of the support leg. When the support leg
fully touches the floor of the vehicle, you can
release the adjustment knob. Pull the support leg to
make sure it is locked.
Make sure that the support leg is in full contact with
the floor pan of the vehicle.
After the installation of the support foot is complete,
the display window turns green. 9.
7 Press the baby car seat down into the base.
10 One hand holds the handle of the baby car seat
and the other hand pushes the baby car seat so that
the front steel bar engages in the hook 10 -(. 1 and
1) Then push the baby car seat firmly so that the
rear steel bar engages in the hook and locks. 10 -(2
and 2)
8. the baby car seat is secured until you hear an
audible "CLICK" indicating that it is fully engaged.
11 Pull up on the infant carrier module to make sure
it is securely locked into the base.