Operation - Ikea Ribbenas Bedienungsanleitung

ENGLISH

Operation

Control panel
1
2
3
A
B
C
Icons:
1
Refrigerator icon
2
Super cooling / freezing icon
3
Fruit/vegetable icon
4
Drink icon
5
Chilled icon
6
Temperature display
7
Freezer icon
Buttons:
A
Temperature up button
B
Refrigerator/Freezer selection button
C
Temperature down button
D
Variable temperature zone button
E
Lock/Unlock button
Note: Do not use sharp objects to operate the control
panel. They can scratch or damage the control panel.
7
6
5
4
D
E
Switching on
When you connect the mains plug to a power socket,
the appliance switches on and starts operating.
Switching off
To switch off the appliance, disconnect the mains plug
from the power socket.
Display
When the refrigerator is first plugged in, the whole
display illuminates for 3 seconds, and the start-up bell
rings. Then the refrigerator runs according to factory
set temperatures (4°C for refrigerator compartment,
-18°C for freezer compartment, "Drink" for variable
temperature zone).
•
During normal operation, the display shows the
set temperature of the refrigerating chamber or
freezing chamber.
•
In case of a fault in the refrigerator, the display
shows the error code.
Lock/Unlock
The control panel will automatically lock when
inactive for 30 seconds (no control panel operation
or door opening). For any settings the control panel
must be unlocked.
•
To lock the control panel immediately, press the
Lock/Unlock button for 3 seconds. The
out and a buzzer sounds.
•
To unlock, press the Lock/Unlock button for
3 seconds. The icon lights up and a buzzer
sounds.
Setting the temperature of refrigerator
compartment
Recommended temperature: 4°C (factory setting)
To set the temperature:
1. Press the button to select the refrigerating
B
chamber (when selected, the Refrigerator icon will
be lit on the display).
2. Press or to adjust the temperature of
refrigerating chamber.
The temperature can be set from 2°C to 8°C.
Important! If the ambient temperature is high or
the appliance is fully loaded, and the appliance is set
to the lowest temperatures, it may run continuously
causing frost to form on the rear wall. In this
case a higher temperature must be set to allow
automatic defrosting and therefore reduced energy
consumption.
13
icon goes